Quality wood products from around the world.
InterGlobal Forest Overview
MDF board with a hard, fine and smoothly sanded surface, characterised by extremely low formaldehyde emission.
MDF Fibrabel NAF is approved (n° N-14-177) by the by Air Resource Board (ARB) as a no-added formaldehyde based resin (NAF) MDF board (section 93120.3 of the ATCM ‘Airborne Toxic Control Measure’), This implies that formaldehyde emission is less than 0,04 ppm (90% of tested material), with a maximum of 0.06 ppm for every single measurement.
Moreover, MDF Fibrabel NAF holds the German ‘Der Blaue Engel’ certificate for thickness 12 – 25 mm, and is classified as F**** according JIS A 1460, for thickness 9 – 30 mm.
Upon request, this MDF board can be supplied with PEFC, FSC or FSC Controlled Wood certificate.
| Sizes (ft) | Max. width: 8' 4.4", Max. length: 20' 8" |
| Thickness (in) | 23/64 to 1 37/64 |
| Finish | Can be lacquered or finished with paper, foil, melamine, veneer or high-pressure laminate |
| Class | Type L-MDF according to EN 622-5 |
| Certs |
|
MDF Fibrabel NAF is suitable for interior decoration, industrial processing and furniture production. The board can be lacquered or finished with paper, foil, melamine, veneer or high pressure laminate.
The board must be applied in service class 1 (restrictions in temperature and ambient humidity) and can only be used in biological hazard class 1 of EN 335-3. The boards must be protected from any direct contact with water. They must be stacked flat, on a pallet or using a sufficient number of cross members. Boards should not be stored vertically, unless ground contact can be avoided. The board will expand or shrink under variable humidity conditions. Use suitable sawing, milling and drilling tools.